CP5400 - 37mm Thread Adaptor (Part # NP0034)

Use 37mm filters and protect the lens of your CP5400 by attaching this snap on 37mm thread adaptor. The adaptor will snap into the lens cap holding groove on the front of the camera lens. It does come off but not easily enough for it to fall off and damage the lens. There is no vignetting at full wide angle when using a regular filter. Using 2 filters stacked together or a Circular Polarizer will cause vignetting at full wide angle. A 37mm lens cap will be needed. The adaptor can be left on the camera when turning it off.

For use with filters only! Do not use with accessory lenses.

Pictures of the adaptor attached to the 5400

In Stock - $27

CP5400 - 49mm Thread Adaptor (Part # NP0036)

Use 49mm filters and protect the lens of your CP5400 by attaching this snap on 49mm thread adaptor. The adaptor will snap into the lens cap holding groove on the front of the camera lens. It does come off but not easily enough for it to fall off and damage the lens. There is no vignetting at full wide angle when using a Circular Polarizer or regular filter. A 49mm lens cap will be needed. The adaptor can be left on the camera when turning it off.

For use with filters only! Do not use with accessory lenses.

Pictures of the adaptor attached to the 5400

In Stock - $27

CP5400 - 52mm Thread Adaptor (Part # NP0037)

Use 52mm filters and protect the lens of your CP5400 by attaching this snap on 52mm thread adaptor. The adaptor will snap into the lens cap holding groove on the front of the camera lens. It does come off but not easily enough for it to fall off and damage the lens. There is no vignetting at full wide angle when using a Circular Polarizer or regular filter. A 52mm lens cap will be needed. The adaptor can be left on the camera when turning it off.

For use with filters only! Do not use with accessory lenses.

Pictures of the adaptor attached to the 5400

In Stock - $27

The following adaptors should work with the 5400 but have not yet been tested.

UR-E8 / UR-E9 to 37mm Female & 49mm Male Thread Adaptor
(Part # NP0032)

This adaptor screws into the UR-E8 / UR-E9 and provides a 37mm internal thread and a 49mm external thread. This can be used with various adaptors to attach the CP5700 to scopes. Can also be used to reverse mount 35mm camera lenses (With 49mm filter threads ) for macro work.
Check out www.lensadapter.com for scope adaptors.

In Stock - $35

UR-E8 / UR-E9 to "T" Thread Adaptor (Part # NP0031)

Attach you CP5400 to microscopes and scopes using this "T" thread adaptor. You will still require the "T" male thread that corresponds with your scope.

Out of Stock